regrouting tiles is a lot more porous than a lot of people understand. It’s the plaster that retains tile set up and fills while in the area all-around the tiles shielding the sides from finding chipped. When you only ever use water and mops, you truly thrust far more grime into your grout than pulling it up. The right solution to deal with a tiled floor, should be to have it sealed, however you have to to start with get any dust and grime away from the grout and from underneath the tiles prior to you need to do so or perhaps the dust will get sealed in at the same time. This is often perilous with the tile since the filth can erode the grout & tile causing damage to both.
Most cleaning products for tile and grout are fairly harsh and damage them over time. Be careful that you use the mildest solution that will do the job.
Note that the darker the grout is, the harder the build-up of grime and other grime will be to see. Dark grout is commonly used in floors and outdoor tiles areas.
Make sure you seal your grout if it is not already done. Just before you are doing that, even so, you need to get a steam cleaner for steam cleaning the grout. Steam cleaning only uses h2o (steam) so you get rid of the grime without causing damage from acidic cleansing agents. After a thorough cleaning, seal the grout. Be sure that you do this 1-2 times per year. Also, it is important to reseal the grout after any repair is done to the tiles, or maybe the tile is regrouted.
Huge improvements have been made to the steam cleaning process over the last ten years. There is no need to use chemicals to get the tiles or grout clean. Steam cleaners work by using a high pressure to increase the temperature of steam from 100 degrees to 180 degrees. At that point, the steam is known as dry steam.